Ultrasonic Transducer And Horn Analyzer Or Testing And Tuning Power

Ultrasonic Transducer And Horn Analyzer Or Testing And Tuning Power

The two clamps of the tester are respectively clamped on the positive and negative electrodes of the transducer. Note that the transducer should not be electrified and live detection is not allowed. The positive and negative electrodes need to be short circuited. After discharging, clamp the clamp, and then turn on the power supply, open the software of the mobile phone, set the starting frequency and the final frequency, such as 28K transducer or mold, set the starting frequency 27, the ending frequency 29, and then click At first, the curves and parameters come out automatically. All the data can be out in about 30 seconds. Click the linear arrow on the top to understand the linear, logarithmic, GB, GB circle. GB circle is the admittance circle. All the parameters are clear at a glance. If you want to test the frequency of the welding head, you need to screw the welding head to the transducer. At this time, the comprehensive frequency impedance of the welding head and the mold is measured. Attention is needed.

This portable impedance analyzer is mainly used to measure the performance of ultrasonic transducer, ultrasonic horn, piezoelectric ceramics, capacitance and inductance. It is one of the most convenient tools for impedance scanning and characteristic analysis of ultrasonic equipment. No matter where you go, you can quickly and conveniently test the parameter characteristics of the device, and you can share it remotely.

Ultrasonic Transducer And Horn Analyzer Or Testing And Tuning Power