300W Ultrasonic Atomizing Transducer and pcb generator for Green Leaf Vegetables and Fruits

Instructions for the Use of Atomizers

1. Remove the product from the packing box (be careful not to touch the water level detector). Place the atomizing head on the support with a height of not less than 100 mm (see Fig. 1), and then put it in the water container (atomizing effect when the distance between the atomizing sheet and the water surface is about 30-50 mm). There is no obstacle in the space above 100mm of the spray head.

2. connect the input plug of the spray head with the transformer outlet socket, then insert the transformer power into the power supply network, the spray head indicator light is shining, and the spray is generated immediately (if the indicator lights flicker without spray, that is, not enough water).

3. as the atomizer works, the water in the container is continuously consumed. When the water level is lower than the water level detector, it will protect and stop the spray. At this time, the indicator lights will blink, and the spray will continue after the water level is higher than the water level detector.

4. when the atomizer starts working, the amount of fog may be smaller. After a short time, it will tend to be stable. Cold weather will affect the spray quantity. A small amount of hot water can be added to speed up the atomization volume.

5. When the atomizer is not used for a long time, the power plug of the transformer should be unplugged to prevent accidents.

Notes and Maintenance

1. The transformer specified by the manufacturer or equipped by the manufacturer must be used. Before using the transformer, the input voltage labeled by the transformer must be checked whether it matches the local power supply voltage before the power supply can be plugged in.

2. When the atomizer works, it will produce certain heat, which requires the water in the container to dissipate heat. Therefore, in order to ensure the normal operation of the atomizer, there must be enough water in the container. Usually, the water content should be more than 30 liters. The bottom of the atomizer should not be less than 100 mm high from the bottom of the container, or less than 15 liters of water, so as to avoid insufficient heat dissipation conditions affecting product life. If the water is in the flowing state or the heat dissipation condition is good, the amount of water can be reduced accordingly.

3. The upper part of the atomizer should not be covered by debris, and the upper space should be greater than 100mm. Neither can atomizers be placed in sealed containers.

4. can not work at high water temperature. When the temperature is higher than 50 degrees, the overheat protector will work, the spray will stop working, the indicator lamp will be bright and long, and the spray will continue when the water temperature is below 40 degrees. Nor is it allowed to work under freezing conditions.

5. Avoid placing atomizers next to electrical equipment such as TV sets, in order to avoid damp water fog damage to electrical equipment.

6. the transformer should be high away from the spray head to avoid direct splash of water, and the plug connected to the spray head can not be placed in the water.

7. in order to ensure that the spray head works in a good environment, it is necessary to change the water regularly every week and clean the atomizer and water level detector with clean soft cloth, but it can not be cleaned with chemical agents.

8. when the spray head is working, do not put your hand above the spray head, otherwise it will produce tingling sensation.