Active Member
|
[China]
Address: No.4 Shunsha Lane 3rd Section 1st Ring Road,Chengdu,China
Contact name:Xu
Sichuan Xinhuaguang Medical Technology Co.,Ltd. |
|
|
OEM 12ml Light Cure Adhesive Light-curing model resin
Instructions
Wet brush
1. Apply the dental separating agent (silicone oil or petroleum
jelly) to the surface of the model fully.
2. Pour the powder and liquid into two silicone cups respectively
3. After dipping the tip of a clean brush in the liquid, dip a
little powder into a spherical mixture, and apply an appropriate
amount of the mixture on the model to form a two-layer crown model,
and let it solidify naturally.
4. Slowly peel off the cured two-layer crown model.
Compression method
1. Weigh the powder and liquid at a ratio of 2:1 and pour into the
silicone cup to mix
2. Stir gently with a knife to fully mix the powder and liquid, and
quickly form and solidify in the state of the dough.
