Active Member
|
[China]
Address: Guandaohe Village, Yuquan Office, Dangyang City, Hubei Province, China
Contact name:Jason Shao
Sinoma (Yichang) Energy Conservation New Material Co., Ltd. |
|
|
| Size (mm) | Thickness (mm) | Weight (KG) | Edge Profile | Application |
|---|---|---|---|---|
| 1200 x 2400 1220 x 2440 | 4 | 18.00 18.61 | Square-cut edge | Internal cladding |
| 1200 x 2400 1220 x 2440 | 6 | 27.00 27.91 | Square-cut edge/ Recessed edge | Internal/external ceiling |
| 1200 x 2400 | 8 | 36.00 37.21 | Square-cut edge/ Recessed edge | Internal partition External wall cladding Wet area and tile backing Floor underlay |
| 1200 x 2400 1220 x 2440 | 9,10 | 40.50 41.86 45.00 46.51 | Square-cut edge | External wall cladding Wet area and tile backing Floor underlay |
| 1200 x 2400 1220 x 2440 | 12 | 54.00 55.82 | Square-cut edge/ Recessed edge | External wall cladding Wet area and tile backing Floor underlay |
| 1200 x 2400 1220 x 2440 | 15 | 66.27 68.50 | Square-cut edge | Internal partitions with special requirements Elevated Floor |
| 1200 x 2400 1220 x 2440 | 18 | 79.52 82.20 | Square-cut edge | Internal partitions with special requirements Elevated Floor |
| 1200 x 2400 1220 x 2440 | 20 | 88.36 91.33 | Square-cut edge | Internal partitions with special requirements Elevated Floor |
Tools:
No special tools are required. The products can be used with normal
nails, fastened by normal or self-drilling screws and cut by an
electric power saw with a diamond blade.
Fixing:
Sinoma Board can be fixed to both timber (minimum size 1.5 x 3
inches) or steel frames (at least 0.55 mm thickness). The board
must be supported at the edge at intermediate positions with
centers not exceeding 600 mm. Screws must be located more than 12
mm from edges and 50 mm from board corners.
Fastener:
Fasteners can be both nails and screws. It can be nailed directly
to timber supports with round wire nails. For metal screws, the
size and length of the screw depends on the thickness of the board
and the gauge of framing.
Jointing:
Since fibre-cement board is subject to slight dimensional changes,
a butt joint can be used in dry partitioning areas or where an
exposed joint appearance is acceptable. For better water
protection, either flexible acrylic or polyurethane based sealant
can be used to seal gaps of 3-5mm.
Fire Test
Transportation, Handing and Storage:
Deliver SINOMA Board to the project site in the original, unopened
package and store them in fully enclosed space where they will be
protected against damage from humidity, direct sunlight, surface
contamination and other causes of damage. Handle SINOMA Board
carefully to avoid chipping the edges or damaging units in any way.
Handling and storage practices should follow the manufacturer’s
recommended suggestions at all times.
Polished surface
