Metal Pendulum Charpy Izod Impact Strength Tester / Meter / Testing Machine / Equipment / Instrument

Metal Pendulum Charpy Izod Impact Strength Tester / Meter / Testing Machine / Equipment / Instrument

Application:

Semiautomatic Charpy Impact Testing Machine is used for measuring the metal material

resistance performance under dynamic load, in order to determine the material properties

under dynamic load.

Standards:

ISO148, EN10045, ASTM E23, GB/T3808-2002 ,GB/T229-2007.

Specification:

1)Impact Energy:300J,150J

2)Dial scale range and division value:

3)Pendulum torque

4) Pendulum pre-angle: 150 °

5) Distance from pendulum center to impact point (test center): 750MM

6) Impact speed: 5.2M/S

7) Sample support span: 40MM

8) The radius of the end of the sample support: 1-1.5MM

9) Sample support support angle: 0°

10) Impact knife arc radius: 2-2.5MM

11) The angle between the two inclined faces of the impact knife: 30°

12) Impact blade thickness: 16MM

13) Sample specifications: 10 * 10 * 55MM

14) The test machine weight: about 450KG

15) Test machine dimensions: 2124*600*1340MM

16) Power: three-phase three-wire system 50HZ380V180W (main motor)

Standard Configuration

1)The host: one.

2)Pendulum:

Specifications, large pendulum 300J, small pendulum 150J.

Quantity, one each, two in total.

3)Span model: Specifications, L=40. Quantity, one.

4)The sample center block: specifications, L = 40 (V. U) type. Quantity, one.

5)The detacher: quantity, one.

6)Stay moving: Specifications, S = 30. Quantity, one.

7)Hex wrench: Specifications, S=14. Quantity, one.

8)Ground angle screw: Specifications, M16 × 200. Quantity, four sets.

9)The jaws (including the bracket): Quantity, one pay. Note that it is installed on the host.

Working Condition

1) Room temperature in the range of 10-35℃;

2)The relative humidity is not more than 85%;

3)In an environment free of corrosive media;

4)Installed on a concrete foundation with a thickness of not less than 150 mm or fixed on a foundation of more than 880 kg;

5)The level of the installation reference surface on the base is adjusted to within 0.2/1000;