High Efficiency Portable Plate Beveling Machine
Stainless Steel Easy To Operate
Portable hand - propelled groove tool. No smoke, no hot fog, no
vibration. High-speed cutting edge of
multi-grain milling cutter, machining of alloy milling cutter, high
finish of groove, soldering directly. Quick
and convenient indoor and outdoor or limited site operating tools,
one-button soft start, automatic
overload protection. Suitable for K, V, X and Y groove machining.
The cutter is easy to clean and the
unique design is effective to prevent the paint from falling off.
Main performance of the product
PBM-15 groove machine is specially designed for
plate groove and
chamfer, and it is a hand-propelled groove processing tool. It is
chamfering metal plate and groove processing before welding. Light
(compared with similar products), small vibration, easy to operate,
Operation and maintenance
1. Check whether the guide bearing is installed correctly according
to the desired Angle of skew, whether
the fixed plate meets the thickness requirements of the workpiece,
and whether the template meets the
requirements of cutting bevel. Turn the eccentric shaft with a
hexagonal lever to see if the drive piece is
2. For large and heavy workpieces, the groove machine USES manual
guidance, that is, the tool moves
and the workpiece does not move; For small workpieces, the beveling
machine is fixed and the workpiece
is pushed forward by hand.
3. For the groove opening of convex and round workpieces, install
the adjustable bracket with two small
wheels on the end face of the template, and the small wheels will
roll along the surface of the workpiece;
For flat workpiece, one guide wheel can be installed on the end
face of the template.
4. During processing, the tool axis should be basically parallel to
the workpiece edge, and the auxiliary
handle on the guide support should be applied to make the tool
press to the workpiece edge.
5. Regularly oil the lubrication points of guide supports and
The knife must be sharp. The knife has two cutting edges and can be
used on the other side when it is
blunt. When both sides are dull, remove and regrind. The total
length of the regrinding is 10mm. If the
length of the cutter is 95mm, it cannot be used.
7. When the groove machine is used for 200 ~ 300h, the gear box
must be unpacked and refueled, and
the motor shall be repaired.
1. The chamfer surface is smooth,
flat, without oxidation layer, easy to
2. Meet K,V,X and Y welding joints.
3. Applicable to steel plate, cast iron, hard
plastic, and can be processed for
chromium steel and other high strength