Home Companies Shenzhen Creatall Electronics Co., Ltd.

MT3608 DC-DC Step Up Converter Booster Power Supply Module Boost Step-up Board MAX output 28V 2A

Contact Us

[China]

Trade Verify

Address: Address:Floor 2nd.Bldg B. Xin Mao Industrial Zone,Xia Wei Industrial Area, Long Hua District, Shen Zhen City,Guang Dong Province. China

Contact name:alvacheng

Shenzhen Creatall Electronics Co., Ltd.

Verified Suppliers

Trust
Seal
Verified
Supplier
Credit
Check
Capability
Assessment

MT3608 DC-DC Step Up Converter Booster Power Supply Module Boost Step-up Board MAX output 28V 2A

Country/Region	china
Categories	Chargers

Product Details

MT3608:

1.Electrical characteristics
1). The maximum output current: 2 a
2). The input voltage: 2 v ~ 24 v
3). The maximum output voltage: 28 v
4). Efficiency: ＞93%

2.Mechanical properties
1). product size: 36 mm X 17 mm X 14 mm

3.Method of use
The module of the IN+ and - after 2~24v, IN adjusting the potentiometer can adjust output voltage, output voltage is greater than the input voltage

4.Matters needing attention
1). The input voltage should not exceed the maximum input voltage
2). The peak current output current is no more than TV university

When the module to adjust the output voltage may not always match the input voltage, please counterclockwise the potentiometer for more than 20 laps, and then use the module may be normal to adjust the voltage. Method of regulation: potentiometer on the front side of the chest, reverse clock amplifier!

18650 Micro:

Charge module- Linear charging.
Current- 1A adjustable.
Charge precision- 1.5%.
Input voltage- 4.5V-5.5V.
Full charge voltage- 4.2V.
Led indicator- red is charging Green is full charged.
Input interface- micro USB.
Work temperature- -10° to +85°.
Inversed polarity- NO.
Size- small to 25X19X10mm.

NOTE:

1. Ampere meter can only be connected to 5v input end of the module.
2. It is better that the charging current is 37% of the battery capacity. If you charge to the battery of 1000mAH, current of 400 is enough.
3. The connection wire should not be too thick.
4. Make sure the connect point is good.
5. If the input voltage is too high, like 5.2v, the current will be less than 1000mA, it is normal. It is protection function, auto-substract the charging current to avoid burn damage to chip.
6. NO Reveral polarity.