Automatic Hot Rolled Deformed Bar Rolling Mill Equipment 8 T/H - 20 T/H Hourly Output

Automatic Hot Rolled Deformed Bar Rolling Mill Equipment 8 T/H - 20 T/H Hourly Output
 
 
 
 
Process of Hot Rolling Mill Production Line Introduction:
Qualified cold billet lifted to charging roller table by crane to arrive at furnace end of reheating furnace, then to be pushed into reheating furnace for heating by billet pusher. When billet temperature reaches to 1150-1250℃, billet will be pushed out of furnace by billet-out device; via furnace out roller table and working roller table before rolling mill, billet will go into rough rolling mill, intermediate rolling mill and finish rolling mill step by step. The final products will go through remained heat treatment device and be cut by multiple-length flying shear and then arrive to cooling bed for cooling by cooling bed entering device after speed-up roller table. After cooling, by cooling bed exit device, the products will be transferred to run-out roller table, and then go to cut-to-length shear. After cut-to-length cutting and inspection, the final products will be transferred to final product span from final product cross span inspection bracket and then being collected, bundled, weighed, labeled and finally stored.
 
 
 
Engineering Team
Our chief engineer has over 40 years experience of designing rolling mill production line, the engineering team will design professional and satisfactory technical proposal for you, and we will try our best to serve you well!
 
 
 
Standard supply scope