|
[China]
Trade Verify
Address: Rm. 704, No. 30, Binglang Dongli, Siming District, Xiamen, China
Contact name:Chen Junjie
Xiamen Comwinning Imp.&Exp.Co.,Ltd |
|
Verified Suppliers
|
|
|
Temporary Outdoor Rack and Pinion Construction Elevators - SC300 KP-B15
Features
Standardization and universalization of cages make them can be used
as left or right cage freely.
The standardized and universal electrical cabinet, resistance box
and base make them can be replaced wholly or individually, and
their installation position can also be changed.
The electrical cabinet and/or resistance box of the same type
hoists are interchangeable.
Made of Q355B steel.
The hot dip galvanised or dip painting finishing make the inner
wall of pipes also be protected, greatly improve the corrosion
resistance.
The center-setting rack and drive device is of large power
transmission moment, good force balance on drive frame.
Apply helical gearbox with large bearing capacity, small tooth
wear, impact resistance, of which service life is greatly improved
(about 3 times more than worm worm reducer).
Guide rollers of KANGBO hoists are non-eccentric, there is no need
to adjust the clearance of rollers after installation.
Technical Data
| Item & Article No. | SC300BG, KP-B15; |
| Payload capacity | 3,000 kg |
| Lifting speed | 0–60 m/min. |
| Max. lifting height | 250/400 m* |
| Cage width (internal) | 1.5 m |
| Cage length (internal) | 3.2 m |
| Cage height (internal) | 2.35 m |
| Motor control | Frequency Control |
| Engine power | 3x23 kw |
| Gearbox | Helical reducer |
| Safety device type | centrifugal brake |
| Power supply range | 380–500 V, 50 or 60 Hz, 3 phase |
| Mast Section | Square column 650*650*1508 mm with bolted rack |
| Rack module | 8 |
FAQ
What is the advantage of applying non-eccentric rollers on the rack and pinion construction elevators?
After the rack and pinion hoists are installed, the technicians must adjust the position of rollers to ensure the gaps between rollers and mast section pips are proper.
The rollers of lifts drive devices and hoist cars must be adjusted to be in place, and the gaps must be right, or, the elevators will shake or tremble when running.
And adjusting the rollers needs experiances and serious and careful attitude.
KANGBO Group finished this difficult jobs on its production line on behalf of KANGBO construction hoists users.
Apply non-eccentric rollers of elevator cars and drive devices mean the users don't need to adjust the rollers after installation.
Machine certified TUV according to European Regulation EN 12159:2012, EN 60204-1:2006/A1:2009.
