|
[China]
Trade Verify
Address: Rm. 704, No. 30, Binglang Dongli, Siming District, Xiamen, China
Contact name:Chen Junjie
Xiamen Comwinning Imp.&Exp.Co.,Ltd |
|
Verified Suppliers
|
|
|
Anti Fall Protection Q345B Steel Rack And Pinion Elevator
Rack And Pinion Elevator Manufacturing Technique
1. Guide rail system
Guide rail system made of 20# steel that is 4.5mm thick.
2. Gear rack
The gear rack is made of 55# steel and its service life is more
than 10 years.
3. Power system
The operating time of the construction hoist is 10 to 15 years.
4. Safety devices
a. Fall arrest device
b. Loading capacity limiter
c. Limit switch
d. Upper limit protection device
e. Lower limit protection device
f. Door limit protection device
g. Escaping window limit protection device
h. Bell warning device
i. Emergency stop protection device
j. Buffering protection device
k. Motor overload protector
l. Transformer short-circuit protection device
m. Phase sequence protection device
5. Cable
We employ genuine GB cable that is guaranteed on quality.
6. Electrical system
The main devices in the electrical system are all Name Brands, like
Schneider, Siemens.
a. The fan installed helps dissipate the heat effectively.
b. With a time delay relay, the construction lift can stop smoothly
and steadily.
c. Alarm bell informs users of the starting of the fall arrest
device.
d. Failure warning light will send light signals when there is a
failure of the motor or electrical system.
7. Protection fence
The outside fence and fence gate are built with plastic-sprayed
perforated plate.
8. Additional scaling ladder
For each construction hoist, two scaling ladders are added to the
drive system to ensure more convenient and flexible
installation.
Rack And Pinion Elevator Optional Configuration
Rack and pinion elevator cage flap door as loading/unloading ramp.
Sliding Contact Line (Integrated Conductive Rail or Busbar)
specially for rack and pinion lifts.
An intelligent elevator control system, Multi-function Control
System, with functions of fault detect, display and alarm, and
automatic cage landing/stop and floor selector, is available.
Automatic greasing machine for rack and pinion elevator is
availble.
Rack And Pinion Elevator Technical Data
| Item & Article No. | SC200BZ, MP-B07; SC200/200BZ, MP-B08 Rack And Pinion Elevator |
| Payload Capacity | 2,000 KG per Cage |
| Lifting Speed | 0–46 m/min. |
| Max. Lifting Height | 250/400 m* |
| Cage Width (Internal) | 1.5 m |
| Cage Length (Internal) | 3.2 m |
| Cage Height (Internal) | 2.35 m |
| Cage Doors | 3 Doors, Entry Door + Exit Door + Side Door |
| Motor Control | FC (Frequency Control) |
| Engine Power | 2x15 KW per Cage |
| Gearbox | Helical Gearbox |
| Safety Device Type | Centrifugal Brake |
| Power Supply Range | 380–500 V, 50 or 60 Hz, 3 Phase |
| Mast Section | Square Column 650*650*1508 mm with Bolted Rack |
| Rack module | 8 |
| * Increased lifting height on request. 250 m with step-up transformer only. 400 m with step-up/step-down transformer. | |
