Active Member
|
[China]
Address: Building 12, Songshan Lake, Small and Medium-Sized Science and Technology Park, Dongguan City, 523808, Guangdong Province, P.R.China
Contact name:KOMEG
KOMEG Technology Ind Co., Limited |
|
|
The rapid temperature change test chamber is suitable for aerospace products, information electronic
instruments, materials, electrical, electronic products, various electronic components in the environment of
rapid changes in high temperature and low temperature, and to test their performance indicators.
Specification
| Capacity(L) | 5CBM
|
| Temperature range | -70℃ ～ +180℃ |
| Temp Uniformity | ≦ ± 2.0℃
|
| Temp Fluctuation | ±0.5℃ |
| Heat up rate | From -70℃ ↑ +180℃ Average 20℃/min No load .(According to IEC60068-3 Standard )
|
| Humidity range | 10% ,20%R.H,30%～95%R.H (As your requirements )
|
| Cooling rate | From +180℃ down to -70℃ Average 20℃/min No load .(According to IEC60068-3 Standard)
|
Chamber size | Interior size: W 2500x H3000x D 2000 mm
|
| Power | AC 3ψ4W 380V 50Hz (R, S, T, N plus ground) (voltage fluctuation ≦ ± 10%) |
Insulation box |
Workspace volume: W 1700 × H 720 × D 500 mm
Exterior size: Approx W 1360 × H 1750 × D 2300 mm |
Door | Double door, left open. Heating wire was installed at the door frames to prevent
condensation at low temperatures.
|
Observation window | With observation window(according to design), multi-hollow electric insulation
coated glass prevent condensation effectively |
Lighting device | LED Lighting device *1 located on observation window
|
Heater | High quality nickel-chromium alloy wire electric heaters,
Non-contact control mode(SSR) |
Condensate drain hole | With workroom condensate and condensate drain. |
Cable port | Φ50mm*1 located on each side of chamber, with rubber stopper and stainless steel cover
|
Surroundings Environmental | Ambient temp. and humidity operating promise Environmental Temp Range : 5〜35℃,Relatively Humidity:≦85%RH
|
Feathers
1 The entire cabinet is of integral construction. Box structure
2 The inside of the box is made of 1.0mm imported
SUS304B stainless steel plate, the outer side is sprayed
with 1.0mm cold-rolled steel plate, and the insulation material is made of ultra-fine glass insulation cotton.
3 The door seal is made of double-layer silicone rubber
sealing material.
4 The observation window is a multi-layer conductive film
tempered insulating glass with a size of
350×500mm to prevent frosting of the glass at low temperature. The special built-in special safety voltage
heating wire surrounds the heating belt with a supply voltage of 36V, and is equipped with an illumination
lamp for observation. Provide lighting.
5 There is a φ50mm test hole with a plug on the side of the
box. The plug material is low foaming of silicone
rubber, which can withstand high and low temperature, and has thermal insulation performance.
6 An air conditioning cabinet is installed on the rear side
of the cabinet studio, and humidifiers, evaporators,
electric heaters, fans, fan volutes, etc. are installed between them.
7 The temperature sensor is placed at the air outlet.
