Home Companies JINHUA (QINGDAO) HARDFACING TECHNOLOGY CO., LTD.

500A 0.6MPa 2000mm 2T Pipe Rotating Welding Machine

Contact Us

[China]

Trade Verify

Address: Room No.5, 15th Floor, Yuyang Plaza, Bayiqizhong Rd, Fuzhou, P. R. China

Contact name:

JINHUA (QINGDAO) HARDFACING TECHNOLOGY CO., LTD.

Verified Suppliers

Trust
Seal
Verified
Supplier
Credit
Check
Capability
Assessment

500A 0.6MPa 2000mm 2T Pipe Rotating Welding Machine

Country/Region	china
City & Province	fuzhou jiangxi
Categories	Plastic Welders

Product Details

Pipe Automatic Welding Machine, Tube Automatic Welding Machine

I. Machine Instruction

This equipment is composed of lathe bed, head, cross member, manual bracket, pneumatic return sliding table, pneumatic tailstock, elevating mechanism of the torch, welding oscillator, adjusting mechanism of the torch, OTC 500A welding power source, water-cooled torch(equipped with cooling water tank) and electrical control system, etc. It has the features of easy-operation and fast.

1. Lathe Bed

The lathe bed is welded & combined by section bar and steel plate and treated with annealing. The work surfaces can ensure the installation accuracy. The rotating head and 2 support brackets are installed on slideway from the left to the right. The support brackets can be pushed & moved on the slideway manually to adjust the position of the support brackets substantially.

The removable safety shield is installed on the lathe bed.

2. Rotating Head

The swing bearing is composed of swing shafting and box, etc. It is driven by the AC gear motor. Conductive device, detection device and wiring terminal are installed inside it. The rotating speed of main spindle is stepless changing. Self-centering three jaw chuck is installed on the flange plate of the main spindle. Use K11-500D three jaw chuck.

3. Support Bracket

The support bracket is composed of baseplate, guide shaft, guide bushing, support plate, adjusting screw, nut sleeve, pressure plate and roller seat, etc. The V-shaped roller locating seat can go up and down by turning the adjusting screw or adjusting the position of the roller seat to accommodate the workpieces with different diameters. Adjust the position of the support bracket to accommodate the workpieces with different lengths.

II. Main Technical Parameters

Model Name	JHC300
Rated Load Capacity	2T
Workpiece Length Range	≤2000mm
Workpiece Diameter Range	φ80-φ600mm
Rotating Speed of The Main Spindle	0.19-2.2r/min
Elevating Stroke of The Torch	300mm
Manual Adjusting Range of The Torch	X:≥50mm Y:≥50mm
Turnover Angle of The Workpiece	360°
Pressure of The Compressed Air	0.3～0.6MPa
Rated Welding Current	500A
Welding Centre Height	950mm