CA3140AMZ IC Chip BiMOS Operational Amplifier with MOSFET Input/Bipolar Output

CA3140, CA3140A

4.5MHz, BiMOS Operational Amplifier with MOSFET Input/Bipolar Output

The CA3140A and CA3140 are integrated circuit operational amplifiers that combine the advantages of high voltage PMOS transistors with high voltage bipolar transistors on a single monolithic chip.

The CA3140A and CA3140 BiMOS operational amplifiers feature gate protected MOSFET (PMOS) transistors in the input circuit to provide very high input impedance, very low input current, and high speed performance. The CA3140A and CA3140 operate at supply voltage from 4V to 36V (either single or dual supply). These operational amplifiers are internally phase compensated to achieve stable operation in unity gain follower operation, and additionally, have access terminal for a supplementary external capacitor if additional frequency roll-off is desired.

Terminals are also provided for use in applications requiring input offset voltage nulling. The use of PMOS field effect transistors in the input stage results in common mode input voltage capability down to 0.5V below the negative supply terminal, an important attribute for single supply applications. The output stage uses bipolar transistors and includes built-in protection against damage from load terminal short circuiting to either supply rail or to ground.

The CA3140A and CA3140 are intended for operation at supply voltages up to 36V (±18V)

Features

• MOSFET Input Stage

  - Very High Input Impedance (Z_IN) -1.5TΩ (Typ)

  - Very Low Input Current (I_l ) -10pA (Typ) at ±15V

  - Wide Common Mode Input Voltage Range (V_lCR)

  - Can be Swung 0.5V Below Negative Supply Voltage Rail

  - Output Swing Complements Input Common Mode Range

• Directly Replaces Industry Type 741 in Most Applications

• Pb-Free Plus Anneal Available (RoHS Compliant)

Applications

• Ground-Referenced Single Supply Amplifiers in Automobile and Portable Instrumentation

• Sample and Hold Amplifiers

• Long Duration Timers/Multivibrators (µseconds-Minutes-Hours)

• Photocurrent Instrumentation

• Peak Detectors

• Active Filters

• Comparators

• Interface in 5V TTL Systems and Other Low Supply Voltage Systems

• All Standard Operational Amplifier Applications

• Function Generators

• Tone Controls

• Power Supplies

• Portable Instruments

• Intrusion Alarm Systems

Absolute Maximum Ratings

DC Supply Voltage (Between V+ and V- Terminals) . . . . . . . . . 36V

Differential Mode Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . 8V

DC Input Voltage . . . . . . . . . . . . . . . . . . . . . . (V+ +8V) To (V- -0.5V)

Input Terminal Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1mA

Output Short Circuit Duration∞ (Note 2) . . . . . . . . . . . . . . Indefinite

Operating Conditions

Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . -55℃ to 125℃

Thermal Information

Thermal Resistance (Typical, Note 1)       θ_JA (℃/W)       θ_JC (℃/W)

    PDIP Package*. . . . . . . . . . . . . . . . . . . 115                  N/A

    SOIC Package . . . . . . . . . . . . . . . . . . . 165                  N/A

Maximum Junction Temperature (Plastic Package) . . . . . . . 150℃

Maximum Storage Temperature Range. . . . . . . . . . -65℃ to 150℃

Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . 300℃

    (SOIC - Lead Tips Only)

*Pb-free PDIPs can be used for through hole wave solder processing only. They are not intended for use in Reflow solder processing applications.

NOTES:

1. θ_JA is measured with the component mounted on a low effective thermal conductivity test board in free air. See Tech Brief TB379 for details

2. Short circuit may be applied to ground or to either supply.

Pinout

Stock Offer (Hot Sell)