MM74C922N Electronic IC Chips 16-Key Encoder 20-Key Encoder

MM74C922 • MM74C923

16-Key Encoder • 20-Key Encoder

General Description

The MM74C922 and MM74C923 CMOS key encoders provide all the necessary logic to fully encode an array of SPST switches. The keyboard scan can be implemented by either an external clock or external capacitor. These encoders also have on-chip pull-up devices which permit switches with up to 50 kΩ on resistance to be used. No diodes in the switch array are needed to eliminate ghost switches.

The internal debounce circuit needs only a single external capacitor and can be defeated by omitting the capacitor. A Data Available output goes to a high level when a valid keyboard entry has been made. The Data Available output returns to a low level when the entered key is released, even if another key is depressed. The Data Available will return high to indicate acceptance of the new key after a normal debounce period; this two-key roll-over is provided between any two switches.

An internal register remembers the last key pressed even after the key is released. The 3-STATE outputs provide for easy expansion and bus operation and are LPTTL compatible.

Features

■ 50 kΩ maximum switch on resistance

■ On or off chip clock

■ On-chip row pull-up devices

■ 2 key roll-over

■ Keybounce elimination with single capacitor

■ Last key register at outputs

■ 3-STATE output LPTTL compatible

■ Wide supply range: 3V to 15V

■ Low power consumption

Absolute Maximum Ratings(Note 2)

Voltage at Any Pin                                     V_CC − 0.3V to V_CC + 0.3V

Operating Temperature Range

    MM74C922, MM74C923                                        −40°C to +85°C

Storage Temperature Range                                   −65°C to +150°C

Power Dissipation (P_D)

    Dual-In-Line                                                                       700 mW

    Small Outline                                                                     500 mW

Operating V_CC Range                                                         3V to 15V

V_CC                                                                                              18V

Lead Temperature (Soldering, 10 seconds)                             260°C

Note 2: “Absolute Maximum Ratings” are those values beyond which the safety of the device cannot be guaranteed. Except for “Operating Temperature Range” they are not meant to imply that the devices should be operated at these limits. The table of “Electrical Characteristics” provides conditions for actual device operation.

Block Diagram

Stock Offer (Hot Sell)