MC14584BDR2G Electronics Circuit Board Programmed Integrated Semiconductor

MC14584BDR2G Electronics Circuit Board Programmed Integrated Semiconductor

Stock Offer (Hot Sell)

MC14584B

Hex Schmitt Trigger

The MC14584B Hex Schmitt Trigger is constructed with MOS P−channel and N−channel enhancement mode devices in a single monolithic structure. These devices find primary use where low power dissipation and/or high noise immunity is desired. The MC14584B may be used in place of the MC14069UB hex inverter for enhanced noise immunity to “square up” slowly changing waveforms.

Features

• Supply Voltage Range = 3.0 Vdc to 18 Vdc

• Capable of Driving Two Low−power TTL Loads or One Low−power Schottky TTL Load over the Rated Temperature Range

• Double Diode Protection on All Inputs

• Can Be Used to Replace MC14069UB

• For Greater Hysteresis, Use MC14106B which is Pin−for−Pin Replacement for CD40106B and MM74Cl4

• Pb−Free Packages are Available

MAXIMUM RATINGS (Voltages Referenced to V_SS)

Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect device reliability.

1. Temperature Derating:

    Plastic “P and D/DW” Packages: – 7.0 mW/°C From 65°C To 125°C 

This device contains protection circuitry to guard against damage due to high static voltages or electric fields. However, precautions must be taken to avoid applications of any voltage higher than maximum rated voltages to this high−impedance circuit. For proper operation, V_in and V_out should be constrained to the range V_SS (V_in or V_out) V_DD.

Unused inputs must always be tied to an appropriate logic voltage level (e.g., either V_SS or V_DD). Unused outputs must be left open.