FEaTuRES
■ ±15kV ESD protection for RS485 pins
■ 3.3V low-power operation
■ Advanced Receiver-failsafe protection for
open, shorted or terminated lines
■ Up to 256 Transceivers may share Bus
■ Very low load for 8x greater fanout
■ Hot Swap glitch protection RE and DE
■ Thermal shutdown protects against driver
■ Available in three industry standard footprints
■ SP3070E, 3073 and 3076 in Full-Duplex (14 pin)
■ SP3071E, 3074 and 3077 in Full-Duplex (8 pin)
■ SP3072E, 3075 and 3078 in Half-Duplex (8 pin)
■ Three applications-optimized speed grades
■ SP3070E-72E: 250kbps slew-limited
■ SP3073E-75E: 500kbps slew-limited
■ SP3076E-78E: 16Mbps high speed
■ Small form factor SO-narrow packages
■ Industrial (-40 to +85ºC) and Extended
(-40 to +125ºC) temperature grades
aPPlICaTIONS
■ Industrial Control, Utility Meters Building Automation,
Instrumentation, Point of Sale
DESCRIPTION
The SP3070E-3078E differential line transceivers are suitable for
bidirectional communication
on balanced multipoint bus transmission lines and comply with both
RS485 and RS422 EIA
Standards. Each device consists of a differential driver and
differential receiver. All devices
operate from a 3.3V power supply.
High receiver input impedance allows a large number of transceivers
to share a common
data bus while maintaining signal margin and without excessive
loading or use of expensive
repeaters. The high impedance driver output is maintained over the
entire common-mode
voltage range from -7 to +12V. Receivers will failsafe to logic 1
output when inputs are open,
shorted or terminated. Drivers include built-in short-circuit
protection and a thermal-overload
shutdown to protect against excessive power dissipation from bus
contention or cable faults.
All RS485 receiver inputs and driver outputs are ESD protected up
to ±15kV (Air-Gap and
Human Body Model) and up to ±8kV Contact discharge (IEC 1000-4-2).