Active Member
|
[China]
Address: NO. 78, Benchi West Road, Jiuhua Demonstration District, Xiangtan City, Hunan Province, China
Contact name:Sophia Peng
Soundon New Energy Technology Co,.Ltd. |
|
|
7.5Kwh Lifepo4 Home Storage Battery WithSafty And Long Cycle Life For Home Energy Storage
Bess introduction
BESS integrated the energy conversion system (inverter), energy storage battery and BMS, solar charger into one household energy storage system. This system has small volume, the structure is more compact, suitable for family use in areas such as the balcony, attic and garage. Application for small load occasions like family and small store.
System Parameter
| Item | BESS | |
| Solar Power(PV) | Input Voltage Range | 60Vdc ～ 90Vdc(open-circuit voltage) |
| Spec of PV | ≤80A | |
| Max Charging Current to Battery | 10-60A(can be set) | |
Max Conversion Efficiency | 98% | |
| Recommended PV Power | 2500W | |
| (AC) | Input Voltage Range | 165- 275Vac / 85-135Vac |
| Input Frequency Range | 45-65 Hz | |
| Short circuit | fuse | |
System Output | Output Voltage | 220Vac/110Vac±5％ 50Hz/60Hz±1％ |
| Output Power | 2000W | |
| Output Power Factor | ≥0.8(>30% Load) | |
| waveform distortion | inear load≤ 5％ | |
| PV-AC conversion time | Normal:5mS Max: 8mS | |
| Max Efficiency | 84.50% | |
| Inverter overload | 100%-110% alarm,110%-125% 255s shut down,125%-150% 60s shut down | |
| Short Circuit | system automatic shut down | |
| alarm | Abnormal of Power Supply | 1times/4S, 40s automatic shut down the alarm |
Low Voltage of Battery | 1time/ 0.2S | |
| Overload | 1times / 1S | |
| BMS | Balance the Current | 1A |
| Voltage Acquisition | ±2mV | |
| Functions | Protect from over-charge, over-discharge and over current and so on | |
Others | IP grade | IP20 |
| Environment Temp | 0℃ ～ 40℃ | |
| Humidity | 10％ ～ 90％ | |
| Noise | ≤ 50dB | |
| Dimension | 800*282*705mm | |
System schematic
Function model
Solar power(PV)Priority Mode PV
In the Solar power (PV) Priority Mode, the loaded power is supplied by the solar panel
AC Priority Mode
In the Solar power (PV) Priority Mode, the loaded power is supplied by the mains supply input and is outputted to the load through the voltage regulator and the isolation parts to ensure the stability of the outputted power source AC
Energy mode
In the Energy mode, the user can set up the time to charge, set the grid to charge the battery pack at a certain time
Bypass Supply
In the bypass supply mode, the mains supply will directly pass the bypass switch and shift to load power supply. The system will directly enter into bypass supply under the following circumstances (Attention: While there is a bypass supply, there must be a mains supply input)
System Characteristics
Adopt high capacity, high safety LiFePO4 battery
Have two modes off-grid and on grid
can wait for ac power generation and photovoltaic power generation equipment of small micro network system
Adopts modular design, easy to install
