ERIKC FOOVC01357 Replacement Injector control valve F OOV C01 357 bosch injection valve set FOOV C01 357

ERIKC FOOVC01357 Replacement Injector control valve F OOV C01 357 bosch injection valve set FOOV C01 357

Valve Introduction

Valve Picture

Other ERIKC Valve List

ERIKC hot product

Mainly producing and selling CR injectors, nozzles, control valves, valve bonnets, CRIN repair kits, injector adjusting shims, common rail injector testers and repair tools. Besides our own brand we are also the sole agent of UK ERIKC (the former OEM factory of famous international brand common rail Parts).

Injector FAQ

FAQ: What should I do if the high pressure pump fails? Oil metering unit over temperature

Troubleshooting method:

1) Check the wiring harness or ECU corresponding control module; 2) Replace the flow measurement unit.

High-pressure pump failure, how to deal with? Short-circuit of fuel metering unit to ground and power supply

ERIKC Answer: Fault phenomenon:

1) The fault light is on; 2) The rail pressure relief valve opens and the vehicle enters the limp home mode.

Possible Causes:

1) The harness at the low end of the ECU to the fuel metering unit is shorted to a low or high level; 2) The fuel metering unit itself fails; 3) The ECU fails.

Troubleshooting method:

1) Disconnect ECU pin 3.10 and measure the ECU's voltage to ground. The normal is about 3.5V. If it is not within the range, replace the ECU to perform the crossover test; 2) Connect the 3.10 foot, disconnect the corresponding end fitting of the fuel metering unit, and measure the voltage of this end to ground. The normal is about 3.5V. If it is not in the range, the 3.10 corresponding harness is short-circuited to high level (more than 3.5V) or low level (less than 3.5V); 3) The resistance of the measuring fuel measuring unit should be 3Ω.