ABB Module IMDSI14 ABB IMDS-I14 ABB IMDS I14 Digital Input Module 12 month warranty

ABB Module IMDSI14 ABB IMDS-I14 ABB IMDS I14 Digital Input Module 12 month warranty

Product Description:

The overflow numerical value of +32767. If the measured value is below the range, the underflow numerical value of -32767 is set. The input impedance is ca. 330 Ω. The current input has
a self-protecting mechanism. If the input current gets too high, the shunt is switched off and the value for range overflow is generated. About every second, the unit tries to switch on the shunt again. In this way the correct measurement will succeed after the current has reached a normal value again.
The trigger of the self-protecting mechanism is displayed by the red LED Ovl as long as the overload is present. In the PLC system an error message is then stored (FK4, error number 4).

Related Product Recommendation:

Product's Character:

The following figure shows the connection of a 3-wire sensor powered by 24 V DC and of a 2-pole sensor powered electrically isolated. Both sensors work as active current sources 0...20 mA.
It has to be taken into consideration, that in this application the M terminal of the basic unit 07 KT 94 is
the reference potential. AGND1 is not dimensioned for carrying the sum of the sensor currents.Differential inputs are very useful, if analog sensors are used which are remotely non-isolated (e.g. the minus terminal is remotely earthed). Since the earthing potential is not exactly the same as
AGND1, it has to be measured bipolar in order to compensate measuring errors. Additionally, in case of singlepole configuration, AGND1 would be connected directly to the remote earth potential. This would cause inadmissable (and possibly dangerous) earthing loops. In all configurations using differential inputs two adjacent analog inputs belong together (e.g. EW 6,00 and EW 6,01). For configuration, both inputs must be configured for the desired operating mode, see configuration table Fig.

LOT 6 NEW HUBBELL ASSORTED HBL9330 HBL5661 HBL2620 RECEPTACLE PLUG B250164

LOT 2 NEW GATES ASSORTED B50 RBL 53IN X 21/32IN V-BELT B364939

LOT 3 NEW SQUARE D B1.30 THERMAL OVERLOAD HEATER ELEMENT D274464

LOT 28 NEW 2IN IRON 45-DEGREE ELBOW CONDUIT FITTING ASSORTED D239291

NEW CATERPILLAR CAT 9W-9940 MOUNT ASSEMBLY MACHINE REPLACEMENT PART B488037

LOT 2 NEW NERCON HBB7689L ADJUSTING NUT 7/8IN THREAD D362288

LOT 2 NEW TSUBAKI RS100 SINGLE CHAIN CONNECTING OFFSET LINK B381266

LOT 8 CALAMO NORDS DN65 76.1 2-1/2IN STAINLESS CLAMP B373011

LOT 10 NEW TNA TNA-E2301-1 CONNECTOR ELECTRICAL MALE BRASS D233387

NEW 8-1/4IN LENGTH 3-9/16IN OD 10MM WIRE COMPRESSION SPRING D439199

LOT 5 THOMAS&BETTS 2556 1-1/4IN STRAIN RELIEF CORD CONNECTOR STRAIGHT B202910

LOT 2 NEW GATES AX70 TRI POWER 72X1/2IN TIMING BELT B272774

The use of the product: