Active Member
|
[China]
Address: Floor2 , Three Gorges Merchant Building , No.11 Jiuxian Bridge Road Jia, Chaoyang District, Beijing, 100016,China
Contact name:Carol Zhang
Beijing Bangyitong Science And Technology Development Co., Ltd. |
|
|
Powerful fractional CO2 laser skin resurfacing machine
Quick Detail:
1, Remove scar, wrinkle, acne, pigment etc
2, 30W RF metal tube from USA
3, Self-calibration, no maintenance work
Principle:
Fractional Laser System fires a laser beam which is then split inti numbers f microscopic beams, producing tiny dot,or pixel-like treatment zones within the selected area of the skin,leaving the other zones within it perfectly intact. Therefore ,the heat of laser only passes deeply through the fractional damaged area. This allows the skin to heal much faster than if the whole area was treated. During the skin self-resurfacing , a great number of collagen is produced for skin rejuvenation. Eventually the skin will look much healthier and younger.
Applications:
1. Remove acne, acne scar, scar and so on;
2. Dispel wrinkle around the eyes, crow' s-feet, and wrinkle formed
by lack of wate;
3. Effectively reduce the wrinkle on the face, forehead, the joints
and striae gravidarum;
4. Dispel freckle, nevus zygomaticus and other spots formed by
hyperchromic pathological changes;
5. Tighten skin and lift face;
6. Remove striae gravidarum and other deep scars.
Special features :
1. US-imported RF-CO2 laser generator, high quality excellent
performance;
2. Excellent treatment results, perfect skin recovery in short
time after treatment;
3. Humanized operation system and 8’ ’ color touch screen display;
4. Portable & smart design, easy for move and daily
maintenance;
5. Smaller focal spot, stronger penetration and powerful output
energy;
6. Best cost performance, designed for salons and clinics use;
Specifications :
| Electrical Requirements | AC 110V± 10% 60Hz AC 220V± 10% 50Hz | Beam Delivery | 7 joint arm |
| Wavelength | 10600nm | Cooling | Air cooling |
| Aiming wavelength | 635nm | Output mode | Continuous, super pulse, fractional |
| Focal Spot Diameter | 0.2mm | Operating mode | Continuous, operation with, intermittent loading |
| Power of Aiming Beam | ≤ 5mw | Whether Preview or not | Yes |
| Pulse Interval | 1ms-5000ms, every stepping 1ms | Times of scanning | 1th-20 th, every stepping 1th |
| Pulse Width | 0.1ms-10ms, every stepping 0.1ms | ||
| Scanning Mode | Disorder emitting, to one side as the base emitting in order, emitting by maximum distance | ||
| Output Power | 30W (RF metal tube from USA) | ||
| Output Pattern | Beeline, triangle, right square, rectangle, hexagon, rotundity, ellipse and so on | ||
| Spots Interval | 0.1mm-2.6mm, every stepping 0.1mm | ||
| Pattern Size | Diagonal length from 0.1mm to 20mm is adjustable at random | ||
Before and after treatment picture
Treatment interface
What type of anesthesia is used during the procedure?
The whole procedure is done under local or topical anesthesia. You are awake and comfortable the entire time. Prior to the procedure, topical numbing cream is applied for 60-90 minutes. In addition, valium is given prior to the procedure to facilitate relaxation. Using these measures there is usually minimal discomfort during the resurfacing procedure.
