Home Companies WEIFANG JIUJIE MACHINERY ELECTROMAGNETIC EQUIPMENT CO.,LTD

CTS(NB) Series Magnetic drum separators

WEIFANG JIUJIE MACHINERY ELECTROMAGNETIC EQUIPMENT CO.,LTD

CTS(NB) Series Magnetic drum separators

Country/Region China
Categories Other Ceramic Fiber Products

Product Details

CTS(NB) Series Magnetic drum separators

CTS (NB) Serieswet Permanent Magnet Separatorisapplicable tothemining, coal preparation plant andother units, forwetweak magnetic fieldsortingoffine-grainedferromagnetic minerals, orremovethenon-magneticmineralmixture ofstrongmagnetic minerals.

The CTS, CTN and CTB series permanent magnetic cylinder separators have two kinds of structures: rotary and fixed.

The fixed one is suitable for choosing fine strong-magnetic particles in wet and weak magnetic fields. It also can be used to remove the strong-magnetic minerals among non-magnetic minerals. When the slurry flows into the magnetic field, the strong-magnetic minerals are adsorbed on the surface of the cylinder, and the weak-magnetic and non-magnetic minerals are sorted out. And then, the strong-magnetic minerals are brought out of the magnetic field with the cylinder rotating. The rotary one is suitable for choosing fine strong-magnetic (moderately strong-magnetic) particles in dry condition. Due to the high speed rotation, the roll number of the magnetic particle is much higher than the ordinary magnetic separator’s. This has a significant effect on destroying the magnetic agglomeration and improving the rich ore ratio. After separating, the minerals are sorted into magnetic and non-magnetic and excluded from their own mouth. The rotary one is applicable to the rough selection and concentration of the ore particle size of 0.6-6mm.

The one cylinder can be equipped with three types of tank, namely downstream launder (CTS) classification size≤6mm, countercurrent launder (CTN) classification size ≤0.6mm and semi-countercurrent launder (CTB) classification size≤1mm.

1. Adopt advanced magnetic circuit design. The magnetic material is made of magnetic materials with high remanence and high coercivity. They have a very good resistance to demagnetization, providing a strong guarantee for the magnetic effect.

2. With aluminum end caps, stainless steel flange wear

3. Modular structure, easy to install, and easy to adjust the magnetic declination

4. Advanced design, brand motor, reducer and SKF bearing, ensuring the machine runs stably for a long term.

5. The whole machine is made of high-quality material, beautiful and practical.

6. Providing the following common parts according to the customer requirements: 1. bearing, 2. seal, 3. motor, reducer, 4. the active and driven chains, 5. outer drum skin

Machine Installation, Adjustment and Commissioning

Installation and Adjustment

1To check and make sure that all parts should be consistent with the technical conditions of the drawings.

2The permanent magnetic cylinder, the parts, each dimension, installation and adjustment should be strictly inspected.

3Each parts should have no serious magnetic damage or variable defects.

4To check the parts quantity and clean oil according to the drawings and documents.

Commissioning

1After installing, the machine has to run for no less than two hours without being fed ore.

2Before operating, the motor reducer, sealed box, bearing fastening screws should be firm, and the contact surface should be close, no wound foot phenomenon.

3, The roller bearings at both ends of the cylinder must have enough lubricating oil. The reducer has moderate lubricating oil. The adjustment screw of the magnetic system has grease.

4, The cylinder is moved by hand so it has flexible rotation without distortions and abnormal sounds.

Hot Products

CTS(NB) Series Magnetic drum separators CTS (NB) Serieswet Permanent Magnet Separatorisapplicable ...
CTS(NB) Series wet magnetic separator CTS (NB) Serieswet Permanent Magnet Separatorisapplicable ...
CTS (NB) Series wet Permanent Magnet Separator CTS (NB) Series Wet permanent magnetic drum separator ...